Power Supply - Bontempi Music Academy 16 6125 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
E N G L I S H
MAINS SUPPLY
The instrument can be supplied by the AC/DC (Vdc =9V
/ I = 500 mA)
(supplied) conforms to national and international safety
regulations covering electrical appliances. Insert the jack in
the DC 9V socket.
RECOMMENDATIONS: The socket (1) for the adapter plug must
be easily accessible. • Inserting the plug into the socket at the
back of the instrument automatically cuts off supply from the
batteries. • Ensure that the adapter is sufficiently ventilated
and that the ventilation slits are not covered with objects such
as newpapers, tablecloths, curtains, etc. • Do not expose the
adapter to drops or splashes of water. • The AC/DC adaptor
shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on
apparatus. • The AC/DC adaptor is used as disconnect device.
• The AC/DC adaptor of apparatus should not be obstructed
OR should be easily accessed during intended used. • To be
completely disconnect the power input, the AC/DC adaptor of
apparatus shall be disconnected from the mains. • Battery shall
not be exposed to excessive heat such as sunshine, fire or the
like. • minimum distances 15cm around the apparatus for suf-
ficient ventilations. • The ventilation should not be impeded by
covering the ventilation openings with items such as newspa-
per, table-cloths, curtains etc. • No naked flame sources such as
lighted candles should be placed on the apparatus. • Attention
should be drawn to the environmental aspects of battery dispo-
sal. • The apparatus should only be used in moderate climates.
WARNING: All batteries or transformers with safety insulation
must be checked regularly for faults in cable, wire, or plug
insulation or other parts.
NOTE: Rating plate information was located at bottom
enclosure of the apparatus.
BATTERY SUPPLY
This instrument works with six 1.5V IEC R6 /AA batteries
(not supplied) which are inserted in the housing at the
bottom.
To open press on the
part of the lid marked
OPEN.
Fit the batteries as
shown at the bottom
of the housing.
2

POWER SUPPLY

positive central adapter
1
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
ADVICE ON USING THE BATTERIES
• Non-rechargeable batteries are NOT to be recharged.
• Rechargeable batteries must be removed from the
product before being charged.
• Rechargeable batteries are only to be charged under
adult supervision.
• Different types of batteries or new and old batteries
are not to be mixed.
• Use only batteries of the same or equivalent type.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries to prevent leakage.
• Do not short circuit supply terminals.
• Remove batteries during long periods of non-use.
WASTE DISPOSAL STANDARDS
For information regarding the disposal of the items men-
tioned here below, please refer to Council Administration
office regarding specialised waste collection centres.
1 - DISPOSAL OF BATTERIES
Protect the environment by disposing
of batteries in the special containers
provided for this use.
2 - PACKAGING DISPOSAL
Take the paper, cardboard and corrugated board to the
appropriate waste collection centres. Plastic material must
be placed in the relevant collection containers.
The symbols indicating the various types of plastic are:
01
02
03
PET
PE
PVC
Key for the different types of plastic materials:
PET= Polyethylene terephtalate
PE= Polyethylene, code 02 for PE-HD, 04 for PE-LD
PVC =Polyvinyl chloride
PP= Polypropylene
PS= Polystyrene, Polystyrene foam
O= Other polymers (ABS, Laminates, etc.)
3. DISPOSING OF ELECTRICAL APPLIANCES
The wheelie bin symbol with a cross indicates
that the product must not be disposed of in
the domestic waste at the end of its useful
life. Instead, it should be taken to your nearest
designated collection point or recycling facility.
Alternatively, check with your retailer and
return the product when buying a replacement, on a one-
to-one basis or as free of charge in case the size is smaller
than 25 cm. Appropriate disposal promotes the recycling
of parts and materials, as well as helping to protect the
environment and human health. Under current legislation,
strict penalties are enforced against those disposing of pro-
ducts illegally. For more information about the collection of
special waste, contact your Local Authority.
05
06
07
PP
PS
O

Publicité

Table des Matières
loading

Table des Matières