Care And Cleaning; What To Do If Repairs Are Needed - Sammic HM-1000 Manuel D'instructions

CARE AND CLEANING

Wipe any spills and splashes inside and outside the oven with a mild detergent solution, rinse, and wipe dry. Do not
use the alkaline detergent. Any food left in the oven could possibly cause arcing due to carbonisation.Never use abra-
sive powders or pads.

WHAT TO DO IF REPAIRS ARE NEEDED

1. Get in contact with your nearest SANYO SERVICE
CENTER. It is dangerous for anyone other than a
properly qualified service engineer trained by SANYO
to carry out adjustments or repairs.
2. If the supply cord is damaged, it must be replaced by a
SANYO SERVICE CENTER, as a special prepared
cord is required.
3. On no account remove or interfere with any parts or
screws. "THIS COULD PROVE VERY DANGEROUS".
Make the following simple check before contacting a
SANYO SERVICE CENTER.
• If the interior lamp does not light when the oven
timer is set:
a. Make sure that the mains lead is securely plugged
in.
b. Make sure that the door is properly closed.
• If the lamp inside lights but the food is not heated:
a. Make sure that the food is not completely covered
with a metal container or aluminium foil.
• Noisy operation:
a. Make sure that sparks are not being produced due
to the use of metal utensils.
b. Make absolutely sure that the contents of the oven
are not touching the oven roof.
17