30WCM WINE CELLAR FEATURES
Insert Wine Bottles
The five (5) pull-out shelves each hold four (4) bottles. See
Front Bottles (Necks Facing Rear)
Figure 14 for typical wine bottle spacing. Care should be taken
Rear Bottles (Necks Facing Front)
when storing extra tall bottles in the wine cradle at the bottom
of the compartment because they may prevent the door from
closing.
Loading Tips and Suggestions
The bottles on the top rack directly under the light will be
exposed to a slightly higher temperature when the light is on.
Position your wines accordingly and REMEMBER TO TURN OFF
THE LIGHT WHEN IT IS NO LONGER NEEDED.
Keep wines that you plan to use for everyday drinking and enter-
taining on the front half of the racks where labels are completely
visible. Place wines for aging or longer term storing in the rear.
Figure 14
Pull-out Racks
The five (5) pull-out wine racks may be pulled out approximately
seven (7) inches to facilitate adding or removing bottles. DO
NOT lean on or press down heavily on the wine shelves. Doing
so may damage the shelves and the wine bottles stored on them.
Pull the wine racks out gently and carefully to minimize unset-
tling your wine collection. Avoid pulling out more than one rack
at any time to maintain stability.
Single Bottle Racks
The single level roll out racks allow you to easily view and access
your inventory without disturbing other bottles (see Figure 16).
Figure 15
Figure 16
18