AGA marvel 30WCM Instructions D'installation, D'utilisation Et D'entretien page 17

Step 9: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay panel to
the door. (See Figure 12).
Step 10: Install lock cam (Models with locks only).
Attach the lock cam to the back of the lock assembly with the
phillips head machine screw provided. Orient the lock cam verti-
cally when installing on the lock.
Step 11: Install door gasket
Press the door gasket into the door channel. Make certain the
gasket corners are fully inserted. If applicable insert the key into
the lock and make certain the lock operates properly.
Step 12: Install the door
Install the top and bottom hinge adapter bushings back into the
hinge adapters that were removed in step 6. Install the door by
reversing the procedure from step 2. Install the top hinge pin so
the screw head is flush with the top surface of the hinge
If applicable insert key into lock and verify the lock cam works
properly with the catch bracket on the front of the refrigerator
cabinet.
Clearance hole through
door gasket channel
#10 Wood Screw
Back of door
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
1.234" (31.3mm)
.991" (25.2mm)
Figure 12
Figure 11
Top hinge pin
Top door hinge
adapter
Top hinge adapter
bushing
Bottom door
hinge adapter
Bottom hinge
adapter bushing
Bottom hinge
cam
Bottom hinge pin
17
Top hinge
Bottom
hinge
Figure 13
Right hand
hinges shown