Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Select Location
The proper location will ensure peak performance of
your appliance. We recommend a location where the ice
machine will be out of direct sunlight and away from heat
sources. To assure your product performs to specifications
the recommended installation location temperature range
is from 55 to 80°F (13 to 27°C) for built in ice machines,
55 to 90°F (13 to 32°C) for freestanding ice machines. Ice
machine will not perform correctly in ambient temperatures
less than 55°F (13°C).
Outdoor Installation
Only the 3OiMT model is suitable for outdoor installations.
Building codes may require a ground fault circuit interrupt-
er electrical receptacle to supply electrical power to the ice
machine for outdoor applications, (see "Electrical Connec-
tion" section).
Do not install in a location where the ice machine will be ex-
posed to direct sun exposure as this may result in unsatis-
factory performance.
Winterizing Your Outdoor Ice Machine
For instructions on winterizing your ice machine see page
22, "Preparing the Ice Machine for Storage".
Cabinet Clearance
Ventilation is required from the bottom front section of the
ice machine. Keep this area open and clear of any obstruc-
tions. Adjacent cabinets and counter top can be installed
around the ice machine as long as the front grille remains
unobstructed.
Front Grille
Do not obstruct the front grille. The openings within the
front grille allow air to flow through the condenser heat ex-
changer. Restrictions to this air flow will result in increased
energy usage and loss of cooling capacity. For this reason
it is important this area to not be obstructed and the grille
openings kept clean. AGA MARVEL does not recommend
the use of a custom made grille as air flow may be restrict-
ed because of inadequate openings. (See Figure 2).
Model
30iMT,3OiMT
Table A
MPRO30iMT
30iMAT
INSTALLING YOUR ICE MACHINE
Minimum
Maximum
Height
Height
33
⁄
"
34
⁄
"
3
3
4
4
(85.7 cm)
(88.3 cm)
31
"
32
⁄
"
1/
1
8
8
(79.1 cm)
(81.6 cm)
Front
Leveling Legs
Leveling Legs
Adjustable legs at the front and rear corners of the appli-
ance should be set so the unit is firmly positioned on the
floor and level from side to side and front to back. The over-
all height of your Marvel appliance may be adjusted higher
(by turning the leveling leg out, CCW) and lower (by turning
the leveling leg in, CW) dimensions as shown in Table "A".
To adjust the leveling legs, place the ice machine on a solid
surface and protect the floor beneath the legs to avoid
scratching the floor. With the assistance of another per-
son, lean the ice machine back to access the front leveling
legs. Raise or lower the legs to the required dimension by
turning the legs. Repeat this process for the rear by tilting
the ice machine forward using caution to prevent the door
from opening. On a level surface check the ice machine for
levelness and adjust accordingly.
The front grille screws may be loosened and the front grille
adjusted to the desired height. When adjustment is com-
plete tighten the two front grille screws. (See Figure 3).
Figure 3
4
Front Grille,
keep this area
open.
Rear
leveling legs
Figure 2
Front Grille
Front grille screw
Publicité
Chapitres
Table des Matières
Dépannage
