Battery Installation - Primos Hunting Sit'N Spin Crazy Critter Instructions

Sit'N Spin Crazy Critter
Model# 62704M

BATTERY INSTALLATION:

Step 1 - Unscrew the bottom housing cap as shown in Fig. 1, then
remove and set aside the exposed screw in the center of the battery
compartment cover.
Step 2 - Remove the battery compartment cover (you may need a
small at screwdriver or pocketknife tip to li up an edge of the
cover). Insert 4 AA batteries (not included) in battery compartment,
following the polarity marks ( at "-" ends facing springs)-see Fig. 2.
Step 3 - Replace battery compartment cover and screw at center of
cover.
Step 4 - Replace bottom housing cap.
SETUP:
Step 1 - Attach Fur Critter:
a) Remove fur critter with spring wire from its storage clips.
b) Loosen thumb screw on critter connection.
c) Insert spring wire into critter connection and tighten
thumb screw.
Step 2 - Attach Ground Stake:
a) Remove ground stake from its storage clip.
b) read ground stake into bottom housing.
OPERATION:
Turn On – Turn speed dial (Fig. 3) clockwise.
a) Increase variable Speed – Turn speed dial clockwise.
b) Decrease variable Speed – Turn speed dial counter clockwise.
Turn O – Turn speed dial counter clockwise until it clicks to o position.
USING SIT'N SPIN CRAZY CRITTER
Insert Sit'N Spin Crazy Critter
wooded areas so it can be seen by predators. Set desired motion speed and start hunting.
e new and improved Sit and Spin Crazy Critter
included 3.5mm cable can be used to connect your decoy to your Primos Electronic Caller and control the
decoy with the caller remote. Compatible with Primos Alpha Dogg
Check the Primos website for the most recently updated list of compatible electronic callers.
Primos® Hunting
604 First St., Flora, MS 39071
(601) 879-9323
www.primos.com
rev030317
Instructions
™
:
TM
ground stake rmly into ground along eld edges, in elds or in
TM
includes a remote control 3.5mm jack.
TM
Fig. 1
Fig. 2
Fig. 3
is jack and
, Turbo Dogg and Boss Dogg
TM TM
.
TM