Operation And Features; Using The Remote Control; Using The Control Panel - RealFlame Firebox 4099 Guide De L'utilisateur

Using the Remote Control

Power
This will turn the unit ON/
OFF. When turned back
ON, the system will recall
its last heat setting used.
Adjust Brightness
This allows you to raise or
lower the level of flame
brightness.
Timed Shut-Off
This allows you to set the
fireplace to automatically
shut OFF after the amount
of time displayed on the
screen. Timer can be set
for ten minutes up to nine
hours.

Using the Control Panel

Timer/Dynamic Embers
This will allow you to set
the automatic shutoff
on the fireplace. Hold
for 5 seconds to switch
to Dynamic Embers.
This function will make
the embers of the fire
automatically glow
dimmer or brighter
creating a realistic fire
effect. Hold 5 seconds
to return to Timer.

OPERATION AND FEATURES

Ambient Light
This will turn the
ambient light above
the logs ON/OFF.
Adjust Heater
This function will
cycle through the
different temperature
levels of the heater.
Hold 5 seconds
to switch readout
between °F and °C.
This will turn the ambient light
This allows programming of
the thermostat. The firebox
heater if desired, simply cycle
no temperature is displayed.
switch temperature readout
embers of the fire automatically
creating a realistic fire effect.
6
Ambient Light
above the logs ON/OFF.
Adjust Temperature
can be used without the
through the function until
Press and hold the down
arrow for five seconds to
from °F to °C and back.
Dynamic Embers
This function will make the
glow dimmer and brighter
Adjust Brightness
This function will
cycle through the
five different levels of
flame brightness.
Power
This will turn the unit
ON/OFF.