Updating The Screen; Enabling / Disabling Android; Touch Operation - Legamaster ETX Serie Manuel De L'utilisateur

OPERATING THE SCREEN / TOUCH OPERATION

5.5. UPDATING THE SCREEN

The ETX-xx20 (PLUS) e-Screens can be updated with a
new firmware version. Updates can be done using a
USB-drive or 'over-the-air'.
5.5.1 Updating the e-Screen using a USB-drive
Load the update.zip file on a USB drive, and insert it
into the USB 2.0 port on the side of the ETX e-Screen.
Go to the settings menu of the ETX e-Screen. In the
'Others' section of the menu, select 'Device'. Select
'System updates' and choose 'local update'. Enter the
pin-code set for the system, then select the USB-drive
with the update.zip file on it. Follow the prompts untill
ready.
After completing the update process, please power-
down the system completely (using the AC-switch).

5.6. ENABLING / DISABLING ANDROID

ETX-XX20 (PLUS) e-Screens offer users the option to disable Android. To disable or enable Android, use the remote
control supplied with the screen.
(slowly) Press: Source / Left / Right / Plus / Minus
A promt will appear (Android enable); select ON to enable Android, Press OFF to disable Android
NOTE: disabling Android limits the functionalities of the screen. Some settings cannot be accessed or changed
after Android has been disabled.

6. TOUCH OPERATION

To be able to control various (enabled) sources using the e-screens touch-functionality, a dedicated connection
between the e-screen and the source is needed using a (supplied) USB cable:
1. Connect the source with the screen using a video cable (VGA / HDMi / Displayport)
2. Use the supplied USB cable to connect the source with the screen, using the USB-A connector for the source
and the USB-B connector with the screen.
3. Turn both the screen and the source on. It may take up to 5 seconds for touch to become active.
4. When a suitable USB-C to USB-C cable is used, video, power-delivery and touch connectivity are
manged over 1 cable.
18
ETX-SERIES – USER MANUAL – ENGLISH
5.5.2 Updating the e-Screen 'over-the-air'
Make sure the ETX e-Screen has an active internet
connection. Go to the settings menu of the ETX
e-Screen. In the 'Others' section of the menu, select
'Device'. Select 'System updates' and choose 'online
update'. Enter the pin-code set for the system. The
system will check for available updates. When a newer
firmware version is available, click the 'download'
button to start the update process.
NOTE: please verify that the correct server URL is
entered:
http://68.66.241.101:8080/ota/upgrade
After completing the update process, please power-
down the system completely (using the AC-switch).