Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Illustration 3
ELECTRICAL OUTLET LOCATION
Outlet should NOT be in the shaded area as indicated on
Illustration 3
NOTE 1:
The floor of the opening should be constructed of
plywood strong enough to support the weight of the
oven and floor load (approximately 100 pounds). The
floor should be level for proper operation of the oven.
Be sure to check the local building code as it may
require that the opening be enclosed with side, ceiling
and rear partition. The proper functioning of the oven
does not require the enclosure.
Screw A
Center Line
Illustration 4
6
EXHAUST DUCT ASSEMBLY
1. Draw a Central Line on floor. Place the Exhaust Duct
in the opening, When the Exhaust Duct Assembly is in
the opening correctly, the Center Line is in the middle
of the Exhaust Duct Assembly.
2. Secure the Exhaust Duct Assembly with the three
screws A.
IMPORTANT: Secure screws in outer hole. 3 pcs are
needed for exhaust duct assembly
IMPORTANT:
Before installing the exhaust duct, confirm the
floor is level.
The level bubble should be equal distance from
level guide lines.
Bottom Mounting Rail
Turn microwave upside down so you are looking at oven
bottom. Secure the bottom Mounting Rail on oven with
four SCREWS A. See Illustration 5.
NOTE: Please make sure to align the holes(marked with
"36") 6 of bottom mounting rail and the holes (marked
with "36") of microwave oven's bottom plate.
Illustration 5
EN
See Illustration . 4
Publicité
Table des Matières
