System Test - Banner BBT HD1+ Manuel De L'utilisateur

16. Press the ◄ ► key to select result printing:
YES or NO. Press «ENTER» to confirm your
choice.
*24V System Test Printing: The printer will
not function for 24 Volt batteries system
test printing. The 24V system test result
will be recorded till you hook up to a 12V
battery and the right screen shows up. Please select "YES" and press
enter key to print the result and then disconnect the clamps. The screen
will appear again after you reconnect the clamps. Please select "NO" and
press the enter key to go back to the main menu.
17. Press «ENTER» return to MAIN MENU or remove the test clamps from the
battery posts after completion of testing batteries to end test.

SYSTEM TEST:

1. Select "SYSTEM TEST" from the main menu.
2. Turn off all vehicle accessory loads such as light,
air conditioning, radio, etc. Before starting the
engine.
3. When the engine is started, one of the three results will be displayed along
with the actual reading measured.
CRANKING VOLTS NORMAL
The system is showing normal draw. Press
«ENTER» to perform the charging system test.
Version 04/2020
PRINT RESULT?
YES/NO
PRINT 24V SYSTEM
RESULT? YES
NO
SYSTEM TEST
xx.xx V
TURN OFF LOADS
START ENGINE
CRANKING VOLTS
xx.xx V NORMAL
12