Orbegozo EX 3050 Manuel D'instructions page 14

EX 3050
3. Place a jug on removable shelf. Make sure the steam control knob is on the "OFF" position.
Note: The appliance is not equipped with jug, please use yourself jug or coffee cup.
4. Connect to power source; press the "Warming up for Coffee" button, the indication lamp flashing. Then
wait until the indicator light keeps on.
5. Pressing ON/OFF Coffee button and water will flow out.
6. After water not dropping out any more, you can pour the water in each container out then clean them
thoroughly, now you can start brewing.
BASIC USE OF THE COFFEE MAKER
1. Preheat the coffee maker: Press button "Warming up for Coffee". While the pilot flashes, the coffee
maker is preheating. Once the light keeps on, the device is ready to make coffee. In order to stop
preheating, press again "Warming up for Coffee".
2. Make coffee: Once the pilot light on "Warming up for Coffee" keeps on, press "ON/OFF Coffee" and the
coffee will start falling to the cup. Press again "ON/OFF Coffee" in order to stop coffee from falling.
3. Preheat steam: Press "Warming up for steam" in order to preheat steam. While pilot light flashes, the
coffee maker is preheating. Once the light is fixed, the device is ready to eject steam. If you wish to
cancel the preheating, press again "Warming up for steam".
4. Steam control knob: Once the light of the "Warming up for steam" is fixed, the unit can eject steam. In
order to do so, turn the steam knob anti-clockwise. If you want not stop ejecting steam, turn the knob
clockwise.
MAKE AN ESPRESSO COFFEE
1. Remove the detachable tank and open the tank cover to fill it with desired water, the water level should
not exceed the "MAX" mark in the tank. Then, place the tank in the appliance properly.
2. Select the one-cup or two –cup mesh, set stainless steel mesh into metal funnel and fill it with coffee,
with the help of the measuring spoon and tamper. Pull the press bar backward, make sure the tube on
the funnel aligns with groove in the appliance, then insert the funnel into the appliance from the
"Insert" position and release the press bar, and you can fix them into coffee maker firmly through turn it
anticlockwise until it is at the "lock" position. (See fig. 1).
3. Place an espresso cup (not provided) on removable shelf.
4. Then connecting the appliance to power supply source. Make sure the steam control knob is on the
"OFF" or "0" position.
5. Press the "Warming up for Coffee" switch, the "Warming up for Coffee" indication lamp flashing. Then
wait until the indicator light keeps on. Then press the "ON/OFF Coffee", and the coffee will start flowing
out through the funnel. Once you have the desired amount of coffee, press "ON/OFF Coffee" and the
coffee will stop flowing.
6. Press "Warming up for Coffee" and the coffee maker will turn off.
7. After finishing making the coffee, you can take the metal funnel out through turn clockwise, and then
pour the coffee residue out with the steel mesh pressed by mesh support bar.
14