Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 8:
Take the protective earth wire (yellow/green) and
connect it to the green screw with an earth icon at
the back of the camera.
Then connect the cable from the LampCam to the
black junction box located at the mounting bracket.
8
Up
Connect here
Step 9:
Install the LampCam on the mounting bracket.
9
Step 10:
Fasten the screw to the mounting bracket using the
included hex wrench.
10
Step 11:
Adjust the tilt angle of the LampCam by fasting the
"adjustment screws".
11
Step 12:
Adjust the horizontal angle of the LampCam approx
30 degrees to left or right. Loosen the screw on
the back using the hex wrench included in the
installation accessories set. Screw it firmly when you
are done.
12
pan angle
adjusment screws
Step 13:
Once the installation is completed turn on the
power from the circuit breaker and the led lamp of
the LampCam will power up.
13
tilt adjusment screws
7
Publicité
Table des Matières
