Firmware Upgrade; Factory Reset - Blaupunkt HOS-X20 Manuel

8. Maintenance
•
Please turn off the power and unplug the power cable, if there is any smoke, disgusting smell, or
noise. Please contact your local retailer or customer service center for help.
•
Avoid oil stain and or chemicals tarnishing and damaging the lens surface.
• All the examination and repair work should be done by qualified service engineers. We are not liable
for any problems caused by unauthorized modifications or attempted repair.

8.1. Firmware Upgrade

The LampCam will look for firmware upgrades automatically. When the
LampCam detects a new firmware it will download it automatically. The
next time the user logs on the LampCam the app will ask if the user want to
upgrade the system. Click "OK" to start the Firmware upgrade. This process
takes around 5 minutes.

8.2. Factory Reset

Step 1:
At the bottom of the LampCam open the compartment by unscrewing the screw.
Step 2:
Use the included reset pin and press the reset button for 10 seconds.
Step 3:
The power LED will starting flashing and factory reset will began.
Step 4:
This process would take around 60 seconds. Wait until the LampCam makes a double beep
tone and the Blue LED indicator starts flashing.
Step 5:
Close the compartment by placing the cover and fasting the screw into it.
9. Support
NOTE:
•
This manual is for reference only. Slight difference may be found in the user interface.
•
All the designs and software here are subject to change without prior written notice.
•
All trademarks and registered trademarks mentioned are the properties of their respective
owners.
• Please visit our website or contact your local service engineer for more information at:
http://security.blaupunkt-service.com
12
reset button
For more product information, please visit
www.blaupunkt.com/service
Blaupunkt Competence Center Security & Care
www.blaupunkt.com
Security Brand Pro GmbH
Mondstrasse 2-4
85622 Feldkirchen-München, Germany
© Technical changes and errors excepted
reset pin