Table des Matières
Publicité
Installation Guide
User Control Interfaces
ControlSpace
wall-mounted controls are easy to integrate and provide elegant, easy to operate control surfaces for end users.
®
The following interfaces can be used with the ESP-00 II engineered sound processor:
• ControlSpace CC-64 control center (PC 041760) (Figure 2)
Network control of any Bose
• ControlSpace CC-16 zone controller (PC 041761)
Uses CC-16 port. Up to 15 devices can be used with any ESP
engineered sound processor.
• ControlSpace CC-4 room controller (PC 042023)
Uses GPI port: Requires 5 control inputs and one ground termination.
Product Overview
Front Panel
Figure 3. Front Panel View
1 LED Indicators:
POWER Power on or fault-state indication
• Green: Power on, normal operation
• Red: Fatal Error (See "Troubleshooting" on page 20).
STATUS Indicates the operating condition of the unit.
• Green: Configuration loaded, operating normally
• Yellow: DSP resource shortage (delay or cycles)
• Red: Configuration error (See "Troubleshooting" on page 20).
• Off: No configuration loaded
ETHERNET Connection status indication of the Ethernet control network
• Green: Link established
• Yellow: Tx activity
• Red: Rx activity
SERIAL RS-232 or CC-16 serial command status indication. (Does not indicate Serial over Ethernet activity)
• Green: CC-16 controller command transmitted
• Yellow: CC-16 controller command received
• Red: RS-232 Rx/Tx activity
2 Channel signal indicators: 32 LED windows for channel status from each installed expansion card.
3 Slot labels: Numbered expansion card location with corresponding signal indicators.
14
networkable hardware.
®
1
3
Figure 2. CC-64 control center
2
pro.Bose.com
English
Publicité
Table des Matières
