AQUA FORTE UltraBead UB-60 Manuel D'installation Et D'entretien page 5

INSTALLATION INSTRUCTIONS
The lter should be installed as close as possible to the pond/biopool.
Make sure there is drainage available at the place where the lter is to be installed.
If the lter is installed indoors, a correctly sized drain should be installed, to drain o as much water as possible
from the pond/biopool, to avoid ooding risks of the premises or adjoining areas. If this is not done, the lter
manufacturer will not be held liable for possible damage to third parties caused by the lter.
ATTENTION
IMPORTANT: Always leave enough space round the lter in order to perform the necessary examinations and
maintenance during the lter's life.
ASSEMBLY (1)
Follow these indications for a correct assembly of the lter:
1. Place the lter on a horizontal and clean surface.
2. Place the lter in its nal location.
3. Install the selector valve with bypass in the lter. Make sure that the
joints (5) between the valve and the lter are correctly placed.
4. Perform the three connections: pump piping to the "inlet from pump"
connection, valve to the waste drain (Ø63mm) and "return to pond/
biopool" for the return of the ltered water to the pond/biopool.
5. Set the manometer T (1), the joint (2), the manometer (3) and the air
drainage (4). It is not necessary to use te on tape, as the watertightness
is guaranteed in this case by the joint. Do not tighten the manometer T
with a tool, as manually will be su cient.
4
3
5
9 10
1
2 ASSEMBLY (2)
Install the bottom drain valve (9) by using the joint (10) on the
threaded bottom outlet and (hand tighten only, no tools). You can
position the blue handle of the ball valve on top by loosening the
6 grey nut of the ball valve and turning the valve.
BEAD LOAD
7
Load up when the lter is installed in position and the connection
pipes have been joined.
8
1. Unscrew and remove the cover (6).
2. Remove the transparent cover (7) and the O-ring (8).
3. Check that all collector arms are in good condition.
4. Fill the lter with water to half capacity.
5. Pour the beads slowly and very carefully inside the lter.
6. Clean the seating of the lid joint.
7. Place the O-ring (8) and transparent cover (7).
8. Screw on the cover (6).
Attention: when operating check that water does not leak from the
lter through the cover.
Note: the manufacturer will not be held responsible for any damage
caused to the lter while lling it with beads.
2
3
Assembly of the manometer (with valve)
AQUAFORTE ULTRABEAD MANUAL • 5
4
1