Installation Instructions - AQUA FORTE UltraBead UB-60 Manuel D'installation Et D'entretien

INSTALLATION INSTRUCTIONS

Pre- lters: as the inlet/outlet pipework system of the bead lters have small openings of ±1,5mm
you cannot pump dirty pond water directly into a bead lter as the waste particles will block these openings.
Always use a pre- lter that is capable of ltering out these waste particles rst!
Below we give a few examples of possible pre- lter options:
GRAVITY FED SIEVE FILTER SYSTEM
The water travels in gravity from the bottom drain and skimmer to the Sieve lter. From the Sieve lter the water is
pumped into the Bead lter and goes back to the pond through a UVC-unit.
GRAVITY FED DRUMFILTER SYSTEM
The water travels in gravity from the bottom drain and skimmer to the Drum lter. From the Drum lter the water is
pumped into the Bead lter and goes back to the pond through a UVC-unit.
INLINE PIPE PRE-FILTER SYSTEM
When the technical room is lower than the water level of the pond we can use the AquaForte inline pipe pre- lter system
(RD430) as an alternative pre- lter. The rest of the system can be the same as in the above examples. When you install 2 or 3
in parallel you can clean them one by one without stopping the pump.
skimmer
Bottom drain
Skimmer
Bottom drain
skimmer
Bottom drain
Slidevalves
Sieve filter
slidevlave
slidevlave
"inline pipe"
pre-filters
AQUAFORTE ULTRABEAD MANUAL • 3
U
V
C
Pump
Beadfilter
U
V
C
Pump
U
V
C
Pump
Beadfilter