Basic Functions - AEI Security DIGISENDER HQ2 Mode D'emploi

ENGLISH (EN)
All manuals and user guides at all-guides.com
DG258 - DigiSender® HQ2 - Twin Input 5.8GHz Wireless AV Sender
Using the DigiSender® HQ2

Basic Functions

Turning the DigiSender® HQ2 On and Off
To turn the DigiSender® HQ2 On, press the power button on the front of the Transmitter and Receiver.
The power button will light up blue to indicate that the unit is switched on.
To turn the DigiSender® HQ2 Off, press and hold the power button on the front of the Transmitter
and Receiver for approximately 3 seconds.
Alternatively you can turn the units On and Off by pressing the power button on the DigiSender®
Remote Control.
Selecting the Input
To select Input 1 (the source device attached to DigiConnector™ 1) press the blue power button on
the front of the Transmitter once.
Input LED 1 will light up red to indicate that the unit is set to input 1.
To select Input 2 (the source device attached to DigiConnector™ 2) press the blue power button on
the front of the Transmitter a second time.
Input LED 2 will light up red to indicate that the unit is set to input 2.
Alternatively you can select the Input by pressing the button labelled 'Input 1' or 'Input 2' on the
DigiSender® Remote Control at the transmitting location.
Please note that you can only switch inputs at the transmitting location and not the receiving
location.
Please read this instruction manual carefully prior to installation Page 11