Trouble Shooting Guide - SamplexPower PST-300-12 Manuel Du Propriétaire

seCtIOn 11 |
iSSUe
When switched ON, Status
LED (2) does not light. Buzzer
is Off. There is no AC output
voltage. GREEN indication
light on the GfCI is Off.
Low AC output voltage
(No buzzer alarm).
Buzzer alarm is sounded when
load is switched ON. Voltage
at DC input terminals reads
between 10 to 10.5V for 12V
versions and between 20 to
21.0V for 24V versions. Status
LED (2) is GREEN. Indication
light on the GfCI is GREEN.
AC output voltage is available.
Buzzer alarm is sounded
when load is switched ON.
Voltage at the DC input termi-
nals reads below 10V for 12V
versions and below 20V for
24V versions. Status LED (2) is
ORANGE. GREEN indication
light on the GfCI is Off. There
is no AC output.

trouble shooting Guide

PoSSiBLe cAUSe
There is no voltage at the
DC input terminals / 12V
power outlet in the vehicle
Polarity of the DC input
voltage has been reversed
that has blown the exter-
nal / internal DC side fuses
(Note: Reverse polarity
may cause permanent
damage).
Low input voltage at the
inverter terminals and the
load is close to the maxi-
mum allowable power.
DC input voltage is less
than 10.5V for 12V
versions and less than
21.0V for 24V versions.
Shut-down due to low
DC input voltage - Less
than 10V for 12V versions
and less than 20V for 24V
versions.
ReMeDY
Check the continuity of the battery
input circuit.
Check that the internal/external battery fuse/
vehicle fuse for 12V power outlet is intact.
Replace if blown. When powered from 12V
power outlet in the vehicle, ensure that the AC
load is less than 150W.
Check that all connections in the battery input
circuit are tight.
Check external and internal fuses. Internal
fuses may be soldered and may not be easily
replaceable. Replace fuses. If unit does not
work, call Technical Support for repair.
Check that the battery is fully charged. Re-
charge, if low.
Check that the battery cables are thick enough
to carry the required current over the required
length. Use thicker cables, if required.
Tighten connections of battery input circuit.
Reduce load.
Check that the battery is fully charged. Re-
charge, if low.
Check that the battery cables are thick enough
to carry the required current over the required
length. Use thicker cables, if required.
Tighten connections of the battery input circuit.
Check that the battery is fully charged. Re-
charge, if low.
Check that the battery cables are thick enough
to carry the required current over the required
length. Use thicker cables, if required.
Tighten connections of the battery input circuit.
SAMLEX AMERICA INC. | 39