Tr Oubleshooting - USRobotics R24.0692.00 Guide D'installation Rapide

Step Four: Verify the Printer's Connectivity
1. Do one of the following:
"
Windows Vista: Click Windows
.
Printers
"
Windows XP: Click Windows
"
Windows 2000: Click Windows
2. Right-click on your printer and select
3. Click
Print Test Page
If the test page fails to print, refer to Troubleshooting for additional information.
N o t e :

Tr oubleshooting

This basic procedure addresses a number of symptoms that you might experience with
your router:
1. Verify the power cord and all the Ethernet cables are connected correctly. This
includes the cables connecting the router, the modem, and all the computers in the
network. See the Installation illustrations on page 3.
2. Ensure that the power outlet to which the router is connected is a live outlet.
3. Refer to the LED descriptions in this guide and then check the LEDs on the router to
make sure you are receiving power and all ports are functioning. See the LED descrip-
tions on page 1.
4. For wireless connections only: Low link quality or range can be caused by environ-
mental interference, such as lead-based paint and concrete walls, or some electronic
items, such as 2.4GHz phones. Try to move the antenna of the router or reposition
the wireless clients to improve the link quality.
5. For wireless connections only: Verify that each device connecting to the router is set
to Infrastructure mode. Set the Network name or SSID in the wireless adapter's set-
tings to the
Network name
same wireless security type. Refer to your wireless adapter's documentation to deter-
mine how to change these settings.
If you still have trouble using the router, see the Troubleshooting section of the User Guide on
the USRobotics Installation CD-ROM.
The Setup Wizard was unable to detect my Internet connection.
Solution:
You will need to manually configure your Internet connection. There are two methods of
instructions you can follow to set up your Internet connection:
If you are still in the Setup Wizard:
1. Do one of the following:
"
Verify the power cord and all the Ethernet cables are connected correctly, then
press
Detect Connection
nection.
"
Manually configure your connection by selecting your Internet connection type:
either
Cable, DSL router, satellite, ISDN, LAN, or other
and any information required by you ISP.
as PPPoE)
Start
Start
Start
Properties
. The test page should print successfully.
that is used in the router, and verify that you are using the
to retry the automatic configuration of your Internet con-
> >
Control Panel
>
Printers and Faxes
> >
Settings Printers
.
or
DSL modem (also known
English
Hardware and Sound
.
.
>
9