Ingersoll Rand 210G Guide Du Produit page 4

Always turn off the air supply and disconnect the air supply hose before installing, removing or
adjusting any accessory on this tool, or before performing any maintenance on this tool.
The direction of the fan can be adjusted from horizontal to vertical be loosening the lock ring and turning the
air cap to the proper location. Hand tighten lock ring after adjustment.
Pattern
Control
Knob
(Dwg. TP2050)
Air Adjustment (If Applicable)
Open the air control knob (Dwg. TP2050) fully by turning counter clockwise. Set desired air pressure using
regulator. Do not exceed maximum air pressure. If a lower air pressure is desired for some parts of the spray
job, turn the air control knob clockwise as needed.
Pattern Control
The pattern control knob (Dwg. TP2050) adjusts the size of the fan. A wide fan will result if the knob is fully
opened by turning it counterclockwise. As the knob is turned clockwise, a smaller round pattern will be
achieved.
Fluid Control
The fluid control knob (Dwg. TP2050) will adjust the atomization of the paint. Turn the knob clockwise until
fully closed. Then while turning the knob counterclockwise, trigger short bursts of paint. This counterclockwise
movement of the knob will move the pattern from fine to coarse. Adjust the knob until the desired pattern is
obtained.
If the pattern is too coarse and the fluid control knob can not adjust it properly, try adjusting the air pressure or
thin the paint to achieve desired pattern.
4
WARNING
Fluid
Control
Knob
Air
Control
Knob
(Dwg. TP2051)
Form 04579611-Edition 2