Marechal Electric DSN Mode D'emploi page 14

►WARNINGS
• MARECHAL ELECTRIC SAS declines any responsibility in the event
of non-observance of applicable standards and instructions
contained in this document.
• These devices must be installed and maintained by a qualified
electrician.
• MARECHAL® devices must be used with MARECHAL®
complementary devices only. Any repair or service must be
performed with genuine MARECHAL® parts only.
• For optimum operation, ensure that the flexible cable does not
hinder the return of the device to its rest position.
• Where there is a risk of deformation of the surface on which the
device is installed, care must be taken to prevent the transmission
of this deformation to the device or its surface box.
• Apply the recommended tightening torques. Do not overtighten
the self-tapping screws.
• Poly box closing screws must be tightened at a torque of 1.2 Nm.
• Beyond certain values of voltage and current, devices may be
used as "Connectors without breaking capacity". They are then
fitted with a red sticker: WARNING - Do not disconnect under load.
Compliance with this warning is the responsibility of the installer
and end-user. It can be performed using of a locking device (see
Optional socket-outlet locking), by the installation itself, or by an
appropriate procedure.
IS 06-2 [DSN] Rev A.0 - 2022-01
14/71 . ,