Section 3 Preparation Of The Rain Logger; Loading The Insight Software; Powering The Rain Logger; Inserting The Rain Reader And Rain Logger In The Cradle - Hach 2458 Mode D'emploi

Section 3 Preparation of the Rain Logger

3.1 Loading the InSight Software

1. Insert the CD into the CD-ROM drive. The CD should automatically run. If the CD does not
automatically run, follow the steps below:
a. Click
b. Click
c. Browse to the CD-ROM drive on your computer and double click setup.exe.
d. Click
2. Follow the instructions as they appear on the screen.

3.2 Powering the Rain Logger

1. Remove the four screws from the face of the Rain Logger and remove the cover.
2. Attach a 9V battery to the battery clip, observing proper polarity.
3. Replace the cover and screw it into place. Be sure to replace the cover as shown in
Figure 5
port on the left side of the rain logger case.
Note: Improper placement of the cover can result in no data being recorded when the Rain Logger is
installed in the Rain Gauge.
Figure 5 Battery Installation
1
1. Screws

3.3 Inserting the Rain Reader and Rain Logger in the Cradle

Insert the Rain Reader and Rain Logger into the cradle. Be sure the Reader is inserted before
the Logger and that the labels face out (see
1. Insert the Rain Reader into the left side of the cradle.
and select the Run function.
START
in the Run dialog box.
BROWSE
in the Run dialog box.
OK
so that the arrows on the cover label point towards the optical communication
3
2. Cover, Rain Logger 3. 9V Battery
Figure 6).
Preparation of the Rain Logger
2
Page 9