Installing The Rain Logger; Remote Rain Logger System - Hach 2458 Mode D'emploi

Installation

4.3 Installing the Rain Logger

1. Slide the Rain Logger into the mounting sleeve in the Rain Gauge with the side marked
TOP
Note: Use care not to tip the bucket during Rain Logger installation since false rainfall will be recorded.
Incorrect placement of the Rain Logger in the Rain Gauge will result in no recorded data.
2. Replace the screen and the rain gauge funnel.

4.4 Remote Rain Logger System

1. Remove the top cover of the Remote Rain Logger housing by rotating it counter-clockwise
to unscrew it from the housing (see
2. Install the Rain Logger in the metal bracket by sliding the top of the Rain Logger into the
leaf springs and snapping the bottom of the Rain Logger under the lip of the metal
bracket. Make sure that the arrows on the Rain Logger label face the same direction as
the arrows on the bracket label.
3. Install two 9V batteries in the holders located on the metal bracket, observing proper
polarity.
4. Replace the top cover of the Remote Rain Logger housing.
5. Attach the cable from the Rain Gauge to the connector on the top of the Remote Rain
Logger housing.
Figure 9 Remote Rain Logger Overview
114.3 mm
( 4.50 inches)
1. Housing, Remote Rain Logger Body
2. Top Cover, Remote Rain Logger
3. Connector
Installing the Rain Logger
Page 14
up (see Figure 8).
1 2
197 mm (7.75 inches)
Figure 10).
3