Installation; Checking Your New Appliance; Codes And Standards; Assembly - MagiCater MCF Serie Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION/OPERATION

INSTALLATION

Checking Your New Appliance

Your new appliance has been carefully packed into one crate. Every effort has been made to ensure that you it
is delivered to you in perfect condition. As you unpack your new appliance, inspect each of the pieces for
damage. If something is damaged, DO NOT sign the bill of lading. Contact the shipper immediately; the shipper
is only responsible for 15 days after delivery. Check the packing list enclosed with your appliance to ensure that
you have received all the parts to the appliance. If you are missing any parts, contact the dealer from whom the
appliance was purchased. As you unpack the appliance and its accessories be careful to keep the weight of the
appliance evenly distributed.
To prevent equipment damage and/or personal injury, do not tilt the appliance onto any
Locate your warranty and fill in the serial number of the appliance and the date of purchase and write them on
the cover of this manual for future reference. You will find the serial number on the date plate located inside the
door or on the back lower panel

Codes and Standards

The fryer must be installed in accordance with:
In the United States:
State and local codes, or in the absence of local codes, with:
National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition).
In Canada:
Local Codes
CSA-B149.1 Natural Gas and Propane Installation Code (latest edition)

Assembly

When you receive your appliance it is completely assembled with the possible exception of the heat deflector.

Heat Deflector Installation

If the appliance requires a heat deflector, you will find a removable label at the rear top edge of the unit. This
label has instructions for positioning and installation of the heat deflector. Refer to the label and the instructions
below to install the deflector.
a.
Remove the two self-drilling screws from the top, back area of the appliance.
b.
Position the heat deflector so that the angled portion of the deflector is facing toward the front of
appliance. Secure the heat deflector to the back of the unit using the two previously removed
fasteners.
c.
When properly installed the angled section of the heat deflector will extend over the flue
opening to redirect the heat. It SHOULD NOT cover the flue opening. Never allow anything to
block the flue opening; this will cause the appliance to overheat and inhibit proper combustion,
which could produce dangerous gases
two of its casters, or pull the appliance by the flue vent.
CAUTION
2

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Mcf14Mcf18

Table des Matières