Osprey POCO LT CHILD CARRIER Mode D'emploi page 7

3. FIT AND SECURE THE CHILD
PREPARE THE CHILD COCKPIT
3.1 Open the Double Halo child harness by releasing
both red harness buckles located below the
child's center back pad.
3.5 Leave your hand behind the back pad to keep it
disconnected while adjusting the seat up or down
to fit the child's size.
POCO LT
ChiLd Carrier
ADJUST CHILD SEAT HEIGHT
To adjust the seat, follow these steps:
3.2 For proper fit, the child's chin should be level
to the top of the drool pad at the front of the
cockpit. Place the child in the carrier to check if
adjustment is needed.
SECURE THE CHILD
3.6 Place child into carrier guiding each leg through
the corresponding left and right Double Halo leg
loops. Ensure proper fit by confirming the child's
chin is level with the top of the drool pad.
WARNING Child must not be in the carrier while adjusting seat height.
3.3 To move the seat into proper position, locate
the child's center back pad that hides the child
harness attachment buckles from Step 3.1. Below
the back pad is a hook-and-loop attachment that
secures the child's seat height in use.
3.7 Guide the child's arms 3.8 Buckle the right and left
through the Double Halo red harness male buckles
harness arm loops. into the red female buckles
located behind the center
back pad.
3.4 Slide a hand underneath the center back pad to
break the hook-and-loop connection.
3.9 Tighten to tension both right
and left straps so that the
harness is snug around the
child's upper torso. The child
is now secure in the cockpit.
English 11