XLC2
Installation
Connect your telephone as shown on the enclosed Quick
Start guide.
Your telephone should arrive pre-assembled. To install it:
1. Remove base from package.
2. Hold one end of your XLC2's long phone line cord tightly.
The correct end to hold should already be plugged into
your phone's jack. Simultaneously pull the other end of the
phone cord away from the phone, unraveling it and allowing
you to plug that end of the cord into a wall telephone
outlet.
3. Plug the loose end of the phone cord into the wall
telephone outlet.
4. Hold one end of your phone's white power adapter cord
tightly. The correct end to hold should already be plugged
into the back of your telephone base unit. Simultaneously
pull the other end of the adapter cord away from the phone,
unraveling it and allowing you to plug that end of the cord
into a wall electrical outlet.
5. Plug white power adapter cord on left rear of the base
into a wall electrical outlet.
6. Remove handset from package.
7. Pull the handset's battery tab located on the bottom of
the device in the direction of the arrow.
8. Place the handset in the base charger. The batteries in the
handset must be fully charged for 10 hours before using the
telephone for the first time.
9. Lift handset and press TALK to test. If you hear a dial
tone, your telephone is ready for use. If not, check all
connections again.
8
XLC2
Installation
apide Guía de Inicio Rápido
E
N
G
L
I
S
H
9