Hilti TE 700-AVR Mode D'emploi page 15

5.4 Removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable
materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Pull the chuck back.
2. Remove the accessory tool.
Note
Use only the recommended grease supplied by Hilti. Use of unsuit-
able grease may cause damage to the product.
5.5 Positioning the chisel
Note
The chisel can be adjusted to 24 different positions (in 15° increments).
This ensures that flat chisels and shaped chisels can always be set to
the optimum working position.
▶ Set the function selector switch to
5.6 Locking the chisel
▶ Set the function selector switch to
5.7 Setting the chiseling power
Note
Chiseling power can be reduced to approx. 70% by pressing the power
level selector switch. The power level LED then lights up, indicating
reduced power.
Chiseling power can be adjusted only when the power tool is switched
on and ready for use. To reselect full chiseling power, press the chiseling
power level selector switch again. Switching off and then on again also
causes the power tool to return to full chiseling power.
▶ Press the power level selector switch.
Printed: 02.02.2017 | Doc-Nr: PUB / 5071172 / 000 / 05
4
5
and position the chisel as desired.
and rotate the chisel until it engages.
English 9