Elster PR6 Instructions page 7

Masquer les pouces Voir aussi pour PR6:
Table des Matières

Publicité

IV
PR7
The PR7 is designed for the Elster range of commercial water meters. Suitable meters are marked with PR7 on the
dial face or around the rim of the shroud.
Das Impulsmodul PR7 ist einsetzbar auf ELSTER Großwasserzählern der Baureihen H4000, H4200, S2000, C4000
und C3100. Hierfür vorbereitete Zähler sind auf Ziffernblatt oder Kopfring mit dem Aufdruck PR7 versehen.
Le PR7 est destine pour a la gamme de compteurs industriels. Les compteurs compatibles sont marques PR7 sur la
façade du totalisateur ou sur le bord de la coiffe.
El PR7 está diseñado para la gama de contadores comerciales de ELSTER
Los contadores en los que se puede instalar el PR7 están marcados en la esfera ó en el anillo de la caja de esfera
1
UK -
Tear off the foil.
DE -
Folie abziehen.
FR -
Déchirer l'opercule.
ES -
Elimine el protector de la parte inferior del PR7
2
UK -
To secure, fit the PR7 onto the water meter with 2 thumb screws.
Ensure the screws are secured tightly. If access is difficult, a flat-
bladed screwdriver may be used.
DE -
Das PR7 wird mit den beiden Rändelschrauben in der rechts
gezeigten Position fixiert.
FR -
Pour fixer le PR7 sur le compteur utiliser les deux vis
poinçonnables. S'assurer que les vis soient suffisamment serrées.
ES -
Para asegurar el PR7 en la esfera del contador, utilice los 2
tornillos apretandolos fuertemente.
3
UK -
Insert the thumbscrew firmly in the tip of the installation aid (only
one end accepts the screws). Hold the top and twist like a
screwdriver to fit the screws in the meter shroud. If necessary,
tighten the thumbscrews using a flat-bladed screw driver.
DE -
Die mitgelieferte Einschraubhilfe kann benutzt werden, falls sich
die Rändelschrauben schwer drehen lassen (siehe Bild rechts).
FR -
Inserer le tournevis dans l'emplacement prevu a cet effet, tenir le
haut et tourner pour fixer les vis sur la coiffe.
ES -
Insertar los tornillos firmemente en la punta del instalador (solo
uno de sus extremos acepta los tornillos). Coja el instalador por el
extremo y rosque los tornillos como si se tratara de un
destornillador.
TEAR OFF
THUMB SCREWS
INSTALLATION AID
INSERT
THUMB SCREWS
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pr7

Table des Matières