Sony LocationFree LF-PK1 Guide De Mise En Route page 29

Register your PSP™ system with the
Base Station
1
Turn on the PSP™ system, and then turn on
the wireless LAN switch of the PSP™ system.
2
Select under
The setting screen for use of LocationFree Player is
displayed. Press the right button to go to the next screen.
3
Select [Start], and then press the
from the home menu.
button.
4
Press the SETUP MODE button on the rear of
the Base Station.
With the Base Station turned on, press and hold the button
until the SETUP MODE LED starts to blink.
Wait until the registration with the Base Station and
network settings for establishing a connection from the
PSP™ system with the Base Station are completed. This is
an automatic process.
Notes
• If more than 5 minutes pass from when the SETUP MODE
LED starts to blink, the LED will go from blinking to fully
lit and the Base Station will no longer register the PSP™
system. In this case, press the SETUP MODE button on the
rear of the Base Station again and hold the button down until
the LED starts to blink.
• If a message stating "Base Station update required" is
displayed, you must perform a software version update. For
details, refer to the Operating Instructions of the LF-PK1.
SETUP
GB
MODE LED
Continued
25 (GB)