Sony LocationFree LF-PK1 Guide De Mise En Route page 19

Make Video Settings with the
LocationFree Player
Configure the on-screen remote control
■
for video
(For the connection to external devices in STEP 1
on page 8)
1
Click anywhere inside the window, and then
click [Settings] at the bottom right of the
window.
 Tip
[Settings] at the bottom right of the window appears only
when you are connected to the Base Station. When you are
not connected, click [Connect] at the bottom left, select the
Base Station you want to set up from the list that appears, click
[Properties], and then click [Video Settings].
2
Select [Video Settings], [Remote Settings],
and then [Video 1] or [Video 2], then select
the make and type of the connected external
device.
 Tip
You can also use "Additional Remote Control Data"
downloadable from the LocationFree Support website at
http://www.sony.net/Products/LocationFree/support/.
If you cannot find the on-screen remote control data of your
external device in the current [Remote Settings] list, try above.
[Settings]
If the configuration above is correct, each time you click
[Power], your external device should turn on or off.*
* After clicking [Power], it takes five seconds or more for the
external device to respond. If it does not respond, make sure
that the make and type are correct, and then try again.
[Power] Select the make.
GB
Select
the type.
Continued
15 (GB)