Technical Data; Removing The Battery - Meec tools 018272 Mode D'emploi

TECHNICAL DATA

Rated voltage
Blowing speed
Weight
Sound pressure level, LpA 78.7 dB(A), K=3 dB
Sound power level, LwA*
Sound power level, LwA** 100 dB(A), K=3 dB
Vibration level
*Measured, **Guaranteed
Always wear ear protection.
The declared vibration value, which has been
measured by a standardised test method, can
be used to compare different tools with each
other and for a preliminary assessment of
exposure. The measurement values have been
determined in accordance with EN 50636-
100:2014.
WARNING!
The actual vibration level when using power
tools may differ from the specified maximum
value, depending on how the tool is used.
It is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start­up time).
DESCRIPTION
1. Handle
2. Speed control
3. Tube lock
4. Blowpipe
5. Outlet blowpipe
6. Power switch
40 VDC
41 m/s
2.5 kg
97.7 dB(A), K=3 dB
<2.5 m/s²
FIG. 1
ASSEMBLY
WARNING!
Always remove the battery from the product
before assembly, otherwise there is a risk of
unintentional starting that can cause serious
personal injury.
FITTING THE BLOWPIPE
1. Hold the product with the logotype
up, press in the tube lock and put the
blowpipe on the outlet.
2. Push the blowpipe onto the outlet so that
the tube lock clicks in place in the opening
in the blowpipe.
3. To blow wet leaves or heavier debris,
fit the high speed nozzle on the outlet on
the product. Check that the nozzle locks in
place over the tab on the nozzle.
FIG. 2
INSERTING THE BATTERY
1. Align the ribs on the battery to the slots in
the product and insert the battery.
2. Check that the battery is locked in place
before use.
FIG. 3
IMPORTANT:
Make sure to align the ribs on the battery
with the slots in the product. Check that the
battery is fully inserted and has locked in
place. There is a risk of damaging the product
if the battery is not correctly inserted.

REMOVING THE BATTERY

1. Switch off the product by releasing the
speed control.
EN
27