Cooling Unit (Additional Equipment) - Kramp MS100 Manuel D'utilisation

6.11 Cooling unit (additional equipment)

6.11.1 Design and function
1
3
1 Water can (capacity 2.5 liters)
2 Metering unit with flexible hose and nozzle
6.11.2 Brief description
03/2015
. Also make sure that the curved knife is securely clamped into the horizontal clamping device
and rests safely against the end stop bolts.
2. Level the cup grinding wheel and the cutting surface into a horizontal position (0 degrees) (page
22, item 6.6 „Adjusting the grinding angle")
3. The work flow is the same as described on page 23, item 6.8.1 "Work flow".
NOTICE!
If not needed, the linear grinding unit can be folded away.
TIP!
Setting the right grinding angle is easier for new knives.
2
The sole purpose of the cooling unit is to counteract the heat generated at the blade while it is being
sharpened.
The cooling unit is operated with a compressed air line (3). Air, through the injector housed in the
metering unit (2), aspirates water from the water can (1) and transports it through the flexible hose to
the nozzle at the knife.
3 Compressed air line (not included)
Knife sharpener MS 100
Operation
25