Burda Combio-868 HE Guide Rapide page 8

Switching on intermediate stage
Precondition: The transmitter is programmed.
1. Press the v switch twice in rapid succession.
2. The heating system operates at 75% capacity.
or
1. Press the b switch twice in rapid succession
2. The heating system operates at 50% capacity.
Deletion of individual transmitters
1. Press simultaneously:
• Programming button P
i
on programmed transmitter
• STOP button
2. Hold down this button combination until the LED goes out
briefly.
Deletion of all transmitters
1. Press simultaneously:
• Programming button P
i
• v-button
on programmed transmitter
• STOP button
• b-button
2. Hold down this combination of buttons until the LED winks
3x and then goes out.
Technical data
Mains voltage 230 V
Frequency 50 Hz
Max. connection 2000 W
Protection class IP 54
Permitted
ambient temperature –20 °C to +30 °C
Cables Mains cable 490 mm (STAS 3)
Cable to heating 235 mm (STAK 3)
Back-up fuse 10 A slow
Max. no of transmitters 16
Important: Note the output of the heating system!
Available accessories (not included in the scope of delivery)
• Cable 3 x 1.5 Y Cable length: 6,5 m
with STAK3 and Schuko connector.
• STAS3 for connection of the heating system
to the radio receiver 2 kW.
Burda Worldwide Technologies
20
Hauptstraße 91 Telefon +49 61 96 64 40 44
D-65843 Sulzbach Fax +49 61 96 64 40 46
Notes on troubleshooting
Fault Cause
No radio reception 1. Transmitter is
not programmed. transmitter
2. No power
supply.
Bad radio reception Change
unfavourable
position
of receiver.
Heating does 1. Heating system
not heat up wrongly
connected.
2. Heating element
is defective.
info@burdawtg.de
www.burdawtg.com We reserve the right to make technical changes
Remedy
Program the
Switch on power
supply.
Change
position
of receiver
or aerial.
1. Check
connection.
2. Replace heating
element.