Mounting Instructions - JBL ProTerra TempSet heat Mode D'emploi

13. The appliance may be used by children over the age of 8 and by persons with a
physical, sensory or mental impairment, as well as by inexperienced persons, if
they are under supervision. They should have received an introduction to how to
use the appliance for this purpose and be aware of the risks of use. The appliance
is not a toy. Children should not clean the appliance or do maintenance or repair
work on it unless they are over the age of 8 and are being supervised.
14. Never spray the appliance and the heat lamp mounted inside with water.
15. Any assembly or mounting deviating from the procedure described in the above
and requiring the removal of electrical connections may only be carried out by a
trained specialist! Improper electrical connections may cause injury from electri-
cal shock and pose a fire hazard!

Mounting instructions:

What you will need:
When mounting on a ventilation screen made from metal: Power drill or rechargeable screw
drill with 4.5 and 25 mm HSS drill bits, screwdriver, sandpaper for metal.
When mounting on a wooden panel: A power drill with a 25 mm HSS drill bit, screwdriver,
sandpaper for wood.
Stick the enclosed self-adhesive drilling template a) onto the upper air screen of

the terrarium from the outside in the spot where you wish to mount the TempSet
heat. The template a) is not needed for terrariums made of wood. However, please
always make sure that the distance from animals and combustible substances is
sufficient.
 Terrariums with ventilation screens made from metal:
Drill two holes of 4.5 mm diameter into the ventilation screen on which you wish to
mount the TempSet heat.
Insert two of the threaded screws supplied with the kit from the inside through the
hang-up hook and the ventilation screen and screw in the two nuts supplied with
the kit from the outside and tighten them.
Terrariums made of wood:
Fasten the hang-up hooks in the designated spot on the terrarium top from the
inside with two self-cutting wood screws.
Terrariums with ventilation screens made from metal:

Stick the enclosed drilling template b) onto the ventilation screen from the outside
at a distance of approx. 10 cm from the mounted hook. Now, please drill the central
hole of 25 mm diameter and the two small holes of 4.5 mm diameter in the ventila-
tion screen.
DE
UK
FR
NL
IT
DK
ES
PT
SE
CZ
PL
RU
9