Controls & Indicators; Led Control Center - Keurig B140 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Adding Water
The LED Control Center of your Brewer will
indicate when the water level in the reservoir is
low or if the Water Reservoir has been removed
by illuminating the blue light next to 'ADD
WATER'. The Brewer will not allow you to brew
when the blue 'ADD WATER' light is illuminated.
ADD WATER
DE-SCALE
HEATING
DRAIN BREWER
AUTO-OFF
POWER
BREW
PUSH TO BREW
The Water Reservoir can be filled in two ways.
1. Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer, then
replace the Lid.
2. Remove the Water Reservoir from Brewer
by first removing Lid from Reservoir, then
lifting Reservoir straight up and away from
Brewer. Fill with water. Place the Water
Reservoir back on the Brewer and replace
the Lid.
3. The blue ADD WATER light will go out 3
seconds after installing or refilling the tank.
This delay is normal.
IMPORTANT: Do not remove the Water
Reservoir during the brewing process.
Draining the Brewer
The Hot Water tank of the B140 can be com-
pletely drained. We recommend that the
Brewer be drained if it is to be transported or
stored for an extended period.
1. The Brewer must be powered on and ready
to brew.
2. Empty the Cold Water Reservoir and place it
back into the brewer. The add water LED will
be flashing.
3. Turn the Brew / Drain selector at the rear of
the brewer to the "DRAIN" position. The
green Drain light will be flashing to indicate
that you may start draining the brewer.
8
4. Press and hold the Drain button. Water will
start to flow from the vent nozzle into the
Water Reservoir. It will continue to flow for
as long as the button is depressed. Flow of
water stops when the drain button is released.
CAUTION: The water may be very hot!
NOTE: The process to drain a Hot Water
Tank from idle state takes about a minute.
5. Release the Drain button, when the flow of
water stops. The brewer's internal hot water
tank is now empty.
6. Turn the valve to the 'BREW' position and
turn off the brewer.
Brewing Hot Water
Your Brewer is able to produce a cup of hot
water for making hot chocolate, for use in
cooking, for making soups, etc. Simply raise
and lower the handle on the Brewer without
adding a K-Cup
®
portion pack. The blue brew
button light will flash... Be sure to have a mug
or cup on the Drip Tray, select a brew size and
then press the Brew Button.
If you are experiencing any problems with
your Brewer, please contact Customer
Service at 1-888-CUP-BREW (287-2739).
SECTION 2
CONTROLS & INDICATORS

LED Control Center

Activating the Auto off Timer Feature
To set the Brewer to turn off two hours after
the last brew.
a. Press the Power Button to turn on the Brewer.
b. Press the black button above the Power
Button to turn the Auto-Off Timer feature on.
The green light next to 'AUTO OFF' will
become illuminated. When the Auto-Off
Timer is enabled, your Brewer will automati-
cally turn off two hours
after your last brew.
c. To turn off the Auto-
Off Timer, simply
press the black button
again and the green
light next to 'AUTO
OFF' will turn off.
ADD WATER
DE-SCALE
HEATING
DRAIN BREWER
AUTO-OFF
POWER
BREW
PUSH TO BREW

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Office pro b145

Table des Matières