Install The Chute Deflector; Install The Chute Control Rod; Operation; Cold Weather Operation - GreenWorks Pro SNC404 Manuel D'opérateur

EN
6.6

INSTALL THE CHUTE DEFLECTOR

1
3
5
2
1. Align the tabs(2) on to the slots(3) on one side first.
2. Once you have engaged one tab on one slot push
until you hear a click. Repeat on other side.
3. Push the chute deflector(1).
4. Make sure that the tabs(2) engage the slots(3) on
the two sides.
5. Make sure that the posts(4) engage the holes(5) on
the two sides.
6.7 INSTALL THE CHUTE CONTROL
ROD
1. Align the holes(1) in the upper chute control rod(2)
and lower chute control rod(3).
2. Put the hitch pin(4) through the holes(1).
3. Align the arrows in the discharge chute and snow
thrower deck. Make sure the discharge chute faces
forward.
4. Put the end of the chute control rod(5) straight
through the hole(6) in the bracket. Keep the grip
handle down.
5. Push the chute control rod(5) into the hole(7) behind
the deck.
6. Turn the grip handle left and right to make sure that
the discharge chute moves in the same direction.
3
5
4
English
7

OPERATION

Wear eye protection during operation.
7.1

COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
Do not store or charge battery outside.
Battery must be charged and stored indoors prior to use
of the machine.
If the machine does not start below 1°F (-17°C),
• remove the battery pack from the machine,
• charge the battery pack for 10 minutes in warm
area, or when the charging light turns green.
• Install the battery pack again.
7.2

START THE MACHINE

2
1
1. While holding the safety switch button(1), pull the
bail lever (2) to start the machine.
Lower the scraper to the ground to remove the snow.
Keep bystanders a safe distance from the machine.
Examine the work area. Remove all stones, sticks,
wire, bones, and other debris that can ricochet
because of the rotating impeller.
8
WARNING
WARNING
NOTE
WARNING
WARNING