oneConcept 10004236 Mode D'emploi page 20

First insert the photo into appropriately sized photo tray(5"x7" (5R), 4"x6" (4R), 3 ½"x5" (3R)). Handle photo
with care. Any dust scratches or fingerprints will show up on your saved images.
20
Open the negative holder at the marked spot on the top. With the negative
holder laid open place the negative into holder so the notches line up with the
notches on the holder. Note: Handle negatives with care. Any dust, scratches
or fingerprints will show up on your saved images. If possible use cotton gloves
when handling negatives. It is recommended to use compressed air to remove
any dust on the negatives. This is not included with the film & photo scanner but
can be purchased from an office supply or electronics retailer.
Close the negative holder and press the edges so that it locks in place Hold it in
the position as shown in the film & photo scanner. Insert the negative holder into
the slot on the right side of the film & photo scanner as shown
Film Holder: The design of the film holder is follow ISO standard. In some cases
the holes on the film will not match exactly to alignment of the holder. This is
caused by a non-standard camera. In this case there will be a small black line
on the edge of the frame that can easily be cropped out using photo editing
software.
Loading Photo