oneConcept 10004236 Mode D'emploi page 19

Hold up the slide toward the light. Face the trade-
mark side of the slide away from you. Look through
the slide and it should appear normally (not a mirror
image). Now turn the slide so the image is upside
down while looking at the same side.
Close the slide holder and press the edges so that it
locks in place.
Loading Slides
1
3
Loading Negatives
Hold up the negative toward the light. As you look through the negative you
should be able to read the small negative numbers normally (not a mirror
image). Now turn the negative so the image is upside down while looking at the
same side.
Open the slide holder at the marked spot on the
top. With the slide holder laid open place the slide
into recessed area in the holder-the slide should fit
perfectly.
Note: Handle slides with care. Any dust scratches
or fingerprints will show up on your saved images.
You' d better to cotton gloves when handling slides.
It is recommended to use compressed air to remo-
ve any dust on the slides. You can purchase it from
an office supply or electronics retailer.
Hold it in the position as shown in the film & photo
scanner. Insert the Slide Holder into the slot from the
right side of the film & photo scanner as shown.
2
4
19