Publicité
Les langues disponibles
Les langues disponibles
EW2604 Mounting:
1. Disassemble the mounting bracket from the light. Drill two holes
in the mounting surface matching the holes in the bracket.
2. Insert the hex head bolts through the mounting bracket and
loosely assemble the bracket onto the light as shown.
3. Secure the light in place with the supplied hardware. Adjust the
light beam angle as needed before tightening the screw on each
side.
WIRING:
The wiring configuration is as shown in Figure 3. All wiring should
be a minimum of 16 AWG. The positive line must have a slow blow
5 amp fuse. Routing the ground wire directly back to negative bat-
tery terminal is recommended. Pack dielectric grease, such as Dow
Corning 4, around each electric connection exposed to moisture or
the ambient environment. The red wire operates the spot light LEDs
and the green wire operates the position LEDs. In-line switches are
optional. Fuse and switches are not included.
Black
Red
Green
5 A
FUSE
In-Line Switch
FIGURE 3
FIGURE 2
Page 2 of 3
Publicité
