Humidity Settings - Stanley ST-12L-DH-E Mode D'emploi

NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Wait 3 minutes after shutdown before restarting to avoid damaging the compressor.
If dehumidifier is damaged, do not use it. The dehumidifier must be serviced by a qualified
person or service agent.
Starting the Dehumidifier:
1. Connect the dehumidifier to the proper electrical
power.
2. Press power button to turn on the unit.
3. The digital display will show the ambient humidity
in the room.
4. Choose fan speed: +/−
5. Choose desired humidity setting, Continuous
(CO) or Automatic (AU).

Humidity Settings:

Continuous Mode (CO)
– Continuous mode will keep the relative humidity
at the chosen constant point.
– The setting range is from 50%-80% relative
humidity.
– When the ambient humidity is 3% lower than the
chosen humidity setting, the compressor will stop.
– When the ambient humidity is 3% higher than
the chosen humidity setting, the compressor will
re-start and maintain the chosen humidity setting.
Continuous Mode Display
Figure 1
© 2018 Obelis S.A Registered Address:
Bd. Général Wahis, 53, 1030 Brussels, Belgium
Safety Information
Operation
Automatic Mode (AU)
– Automatic mode will keep the ambient humidity
constant in relation to the ambient temperature of
the space.
– When the ambient temperature is lower than 5
ºC, the compressor will shutdown while the unit
remains on.
– When the ambient temperature is between
5 ºC and 20 ºC, the space will be kept at 60%
relative humidity automatically.
– When the ambient temperature is between
21 ºC and 27 ºC, the space will be kept at 55%
relative humidity automatically.
– When the ambient temperature is higher than 28
ºC, the space will be kept at 50% relative humidity
automatically.
Figure 2
9
Automatic Mode Display