Smoke hollow DG1100S Mode D'emploi page 17

23
Hardware Needed:
(4) 1/4-20x5/8" Screws
24
Hardware Needed:
(6) 1/4-20x5/8" Screws
ASSEMBLY,
Fig. A
Fig. B
18
ENSAMBLAJE
Attach control panel assembly to cabinet
by carefully angling and feeding the sear
in the front face of the grill and then
to the burner tubes later. Check that
31
Fig. C
Fig. D
1/4 *15 4 PCS
预装。客户松开，
再拧紧
STEP 23:
burner valve through the openings
out the hole in the side of the grill
(Fig.A), (Fig.B) and (Fig.C).
Allow it to hang free for now.
Carefully push each ignition wire
through the holes to be attached
no wires have disconnected
from igniter housing (Fig. D).
Attach the control panel with the
(4) screws from inside the grill.
STEP 24:
From inside of the cabinet,
attach sear burner housing
and lid assembly to cabinet
with (6) screws.
17