Digital Tv; Program Information - LENCO TFT-721 Mode D'emploi

RESET: Reset the picture parameters of screen.
Figure 4.1.3
SYSTEM
C.SYS: Adjust the color mode of TV—Auto, PAL,
SECAM.
S.SYS: Adjust the sound mode of TV—I, L, BG, DK.
SWAP: Let the current channel can exchange to another
channel.
COPY: Let the current channel can copy from another
channel.
Figure 4.1.4
PRESET
AUTO SEARCH: Auto search the TV channels.
SEARCH: Manual search the last/next TV channel, Left
cursor button search the last TV channel,
right cursor button search the next TV
channel.
FINE TUNER: Micro-adjust the current TV signal.
PROGRAM: Display the current channel number.
Skip: If selected, skip the selected channel number when
use CH+/CH- select channel. Select ON means skip;
select OFF means no skip.
Figure 4.1.5
VERSION
Show the version information of system. (Using adapter)
Show the version and battery information of system.
(Using battery)

4.2 Digital TV

4.2.1 Program information

The TFT-721 can display information about TV and radio
programs that are currently being broadcast as well as
those that will be broadcast next.
Some of the advanced functions described here can only
be used if they are included in the program information
transmitted by the broadcasters.
When you change channels, a program information
banner is displayed for a few seconds.
The program information may include:
The current time
The channel name and number.
The names of the current and next programs
The start and stop times of the current program.
The start and stop times of the next program
You can open the main menu by pressing Menu key at
the remote control or front panel. You can perform
different settings enter menus.
1. Display menu by pressing the Menu button; to hide
them, press the menu button again.
2. When menus are displayed, you can move the folders
in horizontal directions with left/right cursor buttons.
The horizontal row contains folders; there are
Channel, Channel Setting, System Setting,
Option and Game folders.
To move a folder into focus, use the left/right
cursor buttons.
When a folder is in focus the bookmarks will be
shown in the title bar.
To confirm the selection, press the OK button,
then it will appear submenu lists.
When you try to open some of the submenu lists
contained in the folders you will be asked to
enter a pin code. This code is pre-set to 888888
in the factory.
Press Menu to open the Menu.
Press OK to open the Channel list menu.
You can always leave a menu at any time you
want, without affecting any settings, by pressing
the Menu button.
5
Figure 4.1.6