Open Window Function - Prem-I-Air Elite EH1550 Mode D'emploi

P
Then press to save the settings for the first day, and move on to the second day
of the week. The  symbol will flash above the figure "2".
Repeat until all seven days have been programmed.
When all seven days have been programmed, press
run the program that has been entered (
The progamming function can be locked to prevent tampering by pressing both the
+ and – keys together and holding down for 3 seconds.
The function can be unlocked to allow programming by pressing both the + and –
keys together again and holding down for 3 seconds.
The display shows [ _ _ ] to indicate that the panel is locked.
Please press the
window sensor. As soon as the device detects a temperature drop of 10° C within
30 minutes, e.g. through an open window, the heating programme is suspended.
The unit automatically switches to standby mode and the symbol lights up
continuously on the display. When the unit detects an increase in room temperature
of 2° C , the heating function is resumed and the window sensor symbol flashes
on the display.
P
Press the and

Open Window Function.

Do not touch the case when the heater is in operation, because it will be hot.
Unplug the heater from the mains when not in use.
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do no use stronger detergents or solvents
as these may damage the plastic.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
Open Window function
P "-"
and buttons simultaneously for 3 seconds to activate the
"-"
buttons simultaneously for 3 seconds again to cancel the
MAINTENANCE
P
shown in the display).

Connect the brown wire to the terminal
labelled "L".

Connect the blue wire to the terminal
labelled "N".

Connect the green/yellow wire to the
terminal labelled with the earth symbol or "E".

Make sure that the cord-grip is
positioned correctly (over the outer sheath of
the cable) and it fully tightened.
6
P
again and the heater will