Prem-I-Air Elite EH1550 Mode D'emploi page 2

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for
future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
INSTALLATION
For free-standing use: Attach the two castor-wheel brackets to the underneath of
the heater using the eight M4x8 mm screws (four in each bracket). The longer side
of the bracket goes at the back of the heater. Attach two castor-wheels to each
bracket using the dome-nuts provided.
To wall-mount: Depress the two clips and remove the wall-mounting bracket from
the heater. Using the bracket as a template, and using a spirit level to makes sure
that the bracket is fitted level, drill four holes in the wall, the lower holes should be
be at least 160 mm above the floor. Insert a wall-plug into each hole. Fix the bracket
to the wall with the four screws supplied. Align the two raised areas on the back of
the heater with the lower part of the bracket, then clip the heater into the bracket at
the top (see photo).
If correctly installed the heater will be firmly fixed at both top and bottom.
PAT TESTING
2