Starting/Stopping Instructions - MTD Yard Machines MTD1416NT Manuel De L'utilisateur

Masquer les pouces

Table des Matières

Les langues disponibles

For Parts Call 606-678-9623 or 606-561-4983

WARNING:

chain properly installed.

STARTING INSTRUCTIONS

1. Fill the oil tank with correct chain and bar oil (Fig. 3).

Use a funnel, wipe up any spills and make sure no dirt

gets into the tank.

NOTE: The saw chain requires lubrication when in use to

minimize friction with the guide bar. The oil tank

holds 4.5 ozs of oil, enough to lubricate the chain

for 12-15 minutes of sawing. We recommend

using original equipment manufacturer Bar and

Sprocket Oil, which contains additives to reduce

friction wear and reduce resin residue formations.

CAUTION:

checked during operation to avoid starving

the bar and chain of lubrication.

NOTE: Your chain saw is equipped with an Automatic

Oiler system and is the ONLY source of

lubrication for the bar and chain.

2. Be certain the Chain Brake® is disengaged before

starting unit (Fig. 4). Disengage it by pulling backward

toward the motor.

3. Hook the extension cord to the extension cord retainer

(A) (Fig. 5) that is built into the rear handle. This will

prevent the cord from pulling out of the handle. Double

the extension cord, about a foot from the end, and

insert it through the hole at the end of the handle.

Hook the loop formed by doubling the cord over the

tab. Gently tug on the cord to ensure that it is firmly

retained in the saws handle. Plug the receptacle end of

the extension cord into the tool's power supply cord.

WARNING:

size and type for your saw.

4. Grip the saw with both hands, left hand holding the

front /handle (DO NOT HOLD CHAIN BRAKE®) and

the right hand holding the rear handle. Thumbs and

fingers should encircle both handles (Fig. 6).

WARNING:

not come in contact with the guide bar and

saw chain.

5. With your right thumb, depress the LOCK/OFF button

time squeeze the trigger. To stop the saw, release the

trigger (Fig. 7).

NOTE: It is not necessary to maintain pressure on the

LOCK/OFF button once the trigger is squeezed

and the motor is running. The LOCK/OFF button

is a safety device to avoid accidental starting.

STOPPING INSTRUCTIONS

The saw motor will automatically stop when the trigger is

released. To restart the motor, you will have to depress

the LOCK/OFF button and squeeze the trigger.