MeisterCraft MWS 650 Manuel D'utilisation page 86

5455060-Winkelschl-man_a 31.01.12 14:09 Seite 86
are connected and properly used.
Use of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to
operate the power tool. Power tools
are dangerous in the hands of
untrained users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
86
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations
different from those intended could
result in a hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
II. Safety notes for all applications
General warnings with regard to
abrasive cutting and roughing:
a This electrical tool is to be used
as a grinder and cutting device.
Pay attention to all of the warning
notes, instructions, diagrams
and data you receive with the unit.
If you do not observe the following
instructions, it may lead to electrical
shock, fire and/or serious injuries.
b This electrical tool is not suitable
for sandpaper sanding, working
with wire brushes, polishing. Uses
for which the tool is not designed
may cause risks and injury.
c Do not use accessories that
have not been designed and
recommended by the manufacturer
for use with this electrical tool.
Just because you can affix an
accessory to your electrical tool,
does not guarantee that it is safe to
use.