Mellerware Vortex Mode D'emploi page 5

3.4.3 Using your Attachments:
3.4.3.1. The Extendable crevice tool is stored on the
side of the vacuum cleaner for convenience.
3.4.3.2. Remove the crevice tool from the side of the
vacuum.
3.4.3.3. Push the one end of the crevice tube into the
hose handle.
3.4.3.4. You can extend the crevice tool for those hard
to reach areas.
3.4.3.5. When are done using the crevice tool you can
remove from hose handle and store back on the side of
the vacuum.
3.4.4 Removing and cleaning the dust bin:
NB: Before carrying out any maintenance or repairs on
your vacuum, ensure that the plug is removed from any
electrical source.
Warning: After each use, always remove the dust bin
and filter and give it a "TAP CLEAN" to remove the dirt
and dust particles. This will ensure a longer life for your
filter.
3.4.4.1. To remove the dust bin, press the dust bin
release button and with your other hand pull the front
handle of the dust bin and remove the dust bin.
31100_IM.indd 5
3.4.4.2. To empty the dust bin, hold the dust bin up-
wards and turn the dust bin cover clockwise to open.
3.4.4.3. Separate the dust bin cover from the dust bin
container.
3.4.4.4. Empty the dust bin container into a dirt bin.
3.4.4.5. The dust bin container and cover can be wiped
down with a damp cloth or rinsed under lukewarm tap
water.
NOTE: Ensure that the dust bin and cover are com-
pletely dry before re-installing into vacuum.
3.4.5 Cleaning / Replacing the HEPA type filter:
3.4.5.1. To remove the filter cover inside the dust
cover, turn counter clockwise and lift.
3.4.5.2. To remove the HEPA type filter, turn the filter
counter clockwise and then pull up.
06-Jul-17 11:28:32 AM