Whale Twist Mode D'emploi page 8

EN
STEP 2.
Allowing for the height and width restrictions
indicated in Fig. 2, drill one 50mm (2") diameter
circular hole in the bulkhead above the water
line. (See Fig. 3) Please note: minimum mounting
surface thickness: 3mm (
maximum mounting surface thickness
19mm ( 3 / ").
4
STEP 3.
Place the housing through the hole. Secure by
hand tightening the lock nut onto the housing
behind the bulkhead. (See Fig. 4a and 4b)
STEP 4.
Feed the hose down through the housing until
the handset is in place. (See Fig. 5)
Please refer to section 8 for plumbing details.
8
1 / ");
8
Fig 3
Fig 4a
In Front of
the Bulkhead
Fig 4b
Behind
the Bulkhead
Fig 5
In Front of
the Bulkhead
In Front of
the Bulkhead