Whale Twist Mode D'emploi page 10

EN
7 ANGLED HOUSING –
INSTALLATION
STEP 1.
Choose a suitable location for the shower to be
installed. The unique design allows the shower
to be fitted on a vertical or angled flat or curved
surface.
Maximum curvature = 1 metre (3ft 3") radius.
Ensure there is sufficient space to allow for the
handset and hose when stowed. (See Fig. 7).
Ensure that the plumbing connections and p
clamp are mounted as close as possible to the
handset housing to ensure maximum usable
hose length.
Please note: Before installing, ensure that sufficient space
is allowed for the shower hose when stowed. Also ensure
that it is free from obstructions when pulled out.
STEP 2.
Drill one 89mm (3 1 / ") diameter circular hole in
2
the fibreglass bulkhead (above the water line).
Minimum bulkhead thickness = 6mm (
Maximum bulkhead thickness = 12mm (
(See Fig. 8)
10
Fig 7
Inside boat
Fig 8
In front of
1 / ")
the bulkhead
4
1 / ")
2
Recommended
minimum depth
allowance
350mm (14")
Recommended
minimum height
allowance
700mm (28")
To valve
Water Level
housing
Deck
Outside boat
Please allow a minimum width of
250 mm (10") for hose stowage