Package Contents - CDVI BO800RN Manuel D'installation

INSTALLATION MANUAL
BO800RN - BO1200RN - PBO400RN - PBO800RN
Retrofi t housing and retrofi t handles

3] PACKAGE CONTENTS

BO800RN (2,5 m)
BO1200RN (2,5 m)
BO800RN (3 m)
BO1200RN (3 m)
PBO800RN (60 cm)
PBO400RN (40 cm)
4] ASSEMBLY
Before commencing assembly, ensure you have the correct tools and accessories depending
on the installation.
1
Position the box-section
complete with pre-fi tted
magnetic locks, on to the door frame
(or fi xed door leaf if installing onto
double doors) – ensure the positioning
will allow for the archi-tectural handle
to close securely over the section. Once
you are satisfi ed with the position,
mark the vertical and
holes, then drill as required. Take note
of the cable entry holes, and feed
the cables through. Fix the section into
place, then wire the electromagnetic
locks in accordance with the wiring
schematic in Section 5. Fit the box
section cover into place, fi r the end caps
and secure with the M4 screws provided.
cdvi.com
4
cdvigroup.com
Profi led handle Profi led handle
with end caps fi xings cover
1
1
1
1
1
1
2
backplate,
To fi nalise the assembly, tighten all
electro-
fi xings, and protect the handle fi xing
section by fi tting the cover and end caps.
horizontal
Box section
back-plate
1 1
1 1
1 1
1 1
1 1
1 1
Box section
End caps
cover
2
1
1
1
1
1
3
With the door closed, position the
architectural handle onto the edge
of the opening leaf of the door, ensuring
the handle covers the box-section.
Mark the vertical and horizontal holes,
drill as required, then
fi x the handle leaving a small gap around
the box section – check the alignment
of the magnets in the box section with
the magnets in the handle. Adjust
if necessary, then once satisfi ed, secure
the handle by completing the fi xings.
EN
2
2
2
2
2
2
temporarily